How hard is the water in Murg?

Murg Flums Energie publishes a total hardness of 7.1 °fH for the supply zone Versorgungsgebiet Murg — that corresponds to 4 °dH. The hardness range is a classification under the German Detergents and Cleaning Products Act (soft below 8,4 °dH, medium 8,4 to 14 °dH, hard above that) and not a quality verdict — it indicates how much calcium and magnesium is dissolved in the water. Basis: 2025, retrieved on 07/08/2026.

How much nitrate is in the drinking water in Murg?

Murg Flums Energie publishes a nitrate value of 2 mg/l for the supply zone Versorgungsgebiet Murg. The statutory parametric value is 40 mg/l; the measured value represents 5 % of the parametric value. Basis: 2025, retrieved on 07/08/2026.

Who supplies the drinking water in Murg?

Murg Flums Energie. The values shown here come from the supply zone Versorgungsgebiet Murg and apply to the water the supplier delivers. What happens between the building connection and the tap — in old lead pipes, for example — is not covered by these analyses; information on that is provided by owners, the health authority or an examination by an accredited laboratory.

Drinking water in Murg

There are 2 places with this name — listed below by area. To determine the exact match, look up the postcode.

How to read the share of the parametric value

12 % Share of the parametric value. The proportion of the permitted maximum that the measured value uses — here 12 %, so just over an eighth.

< 10 % * Below the limit of quantification. The substance was not detectable. The mark shows where the detection limit lies relative to the parametric value — the actual share of the parametric value is below that.

Several samples per year: for chemical parameters the mean value is given, for microbiological ones the highest measured value. There the parametric value is zero — a single finding would disappear in the average, and it is precisely that finding which is the information. Which reference applies is stated in the last column of the table.

Murg (8877)

Versorgungsgebiet Murg

Murg Flums Energie

Assigned via the water supplier — the exact supply zone boundary within the postcode is not yet linked.

Water hardness

4 °dH

Hardness range soft

Key values Versorgungsgebiet Murg
Parameter	Value	Parametric value	Share of the parametric value	Reference
Nitrate	2 mg/l	40 mg/l	5 %	Mean · Versorgungsgebiet Murg
Escherichia coli (E. coli)	0 KBE/100ml	0/100 ml	—	Maximum · Median 0 · Versorgungsgebiet Murg
Sodium	1.5 mg/l	200 mg/l	0.8 %	Mean · Versorgungsgebiet Murg

Show all recorded parameters (12 — most recent value per parameter)

Microbiology (3)

Microbiology – Versorgungsgebiet Murg
Parameter	Value	Parametric value	Share of the parametric value	Reference
Aerobic mesophilic bacteria	2 KBE/ml	300 1/ml	—	Mean · Versorgungsgebiet Murg
Escherichia coli (E. coli)	0 KBE/100ml	0/100 ml	—	Maximum · Median 0 · Versorgungsgebiet Murg
Intestinal enterococci	0 KBE/100ml	0/100 ml	—	Maximum · Median 0 · Versorgungsgebiet Murg

Chemical parameters (1)

Chemical parameters – Versorgungsgebiet Murg
Parameter	Value	Parametric value	Share of the parametric value	Reference
Nitrate	2 mg/l	40 mg/l	5 %	Mean · Versorgungsgebiet Murg

Indicator parameters (4)

Indicator parameters – Versorgungsgebiet Murg
Parameter	Value	Parametric value	Share of the parametric value	Reference
Conductivity (25 °C)	144 µS/cm	—	—	Mean · Versorgungsgebiet Murg
pH	8.16	—	—	Mean · Versorgungsgebiet Murg
Sodium	1.5 mg/l	200 mg/l	0.8 %	Mean · Versorgungsgebiet Murg
Temperature	9.3 °C	—	—	Mean · Versorgungsgebiet Murg

Further parameters (4)

Further parameters – Versorgungsgebiet Murg
Parameter	Value	Parametric value	Share of the parametric value	Reference
Calcium	22 mg/l	—	—	Mean · Versorgungsgebiet Murg
Magnesium	4 mg/l	—	—	Mean · Versorgungsgebiet Murg
Potassium	0.26 mg/l	—	—	Mean · Versorgungsgebiet Murg
Total hardness	7.1 °fH	—	—	Mean · Versorgungsgebiet Murg

Values taken unchanged from the publications linked below — for each parameter the most recent recorded value. „—" in the parametric value column: no currently valid legal parametric value is stored in our database for this parameter; the parameter register with all parametric values is being expanded continuously.

Source: https://trinkwasser.ch/de/versorger/1481/murg-flums-energie/3370/versorgungsgebiet-murg · 2025 · 2025 · retrieved on 07/08/2026

Postcodes in this zone: 8877

Frequently asked questions about drinking water in Murg

How hard is the water in Murg?: Murg Flums Energie publishes a total hardness of 7.1 °fH for the supply zone Versorgungsgebiet Murg — that corresponds to 4 °dH. The hardness range is a classification under the German Detergents and Cleaning Products Act (soft below 8,4 °dH, medium 8,4 to 14 °dH, hard above that) and not a quality verdict — it indicates how much calcium and magnesium is dissolved in the water. Basis: 2025, retrieved on 07/08/2026.
How much nitrate is in the drinking water in Murg?: Murg Flums Energie publishes a nitrate value of 2 mg/l for the supply zone Versorgungsgebiet Murg. The statutory parametric value is 40 mg/l; the measured value represents 5 % of the parametric value. Basis: 2025, retrieved on 07/08/2026.
Who supplies the drinking water in Murg?: Murg Flums Energie. The values shown here come from the supply zone Versorgungsgebiet Murg and apply to the water the supplier delivers. What happens between the building connection and the tap — in old lead pipes, for example — is not covered by these analyses; information on that is provided by owners, the health authority or an examination by an accredited laboratory.

General questions — how current the data is, limit of quantification, parametric values, who is behind this site — are answered under Questions & answers.

No data yet

For postcode 79730 there is no verified assignment yet.